Cuoi Be Bung

You looked a lot like my wife A serious drunk walked into a bar and, after staring for some time at the only woman seated at the bar, walked over to her and kissed her. She jumped up and slapped him silly. He immediately apologized and explained, "I'm sorry. I thought you were my wife. You look exactly like her." "Why you worthless, insufferable, wretched, no good drunk!" she screamed. "Funny," he muttered, "you even sound exactly like her." Would you define OCR? OCR - Optical Character Recognition A technology that can take written words and convert them back into computer-readable form, provided they're in the right font, using the correct colors sometimes, at the right point size and pitch, dark enough on the paper, and you're prepared to spend several centuries correcting all the 1's that came out as l's, all the O's that came out as 0's, and all the :'s that come out like ;'s. By following the instructions below, you should have error-free, long-lasting floppy disks. 1. Never leave diskettes in the disk drive, as data can leak out of the disk and corrode the inner mechanics of the drive. Diskettes should be rolled up and stored in pencil holders. 2. Diskettes should be cleaned and waxed once a week. Microscopic metal particles can be removed by waving a powerful magnet over the surface of the disk. Any stubborn metallic shavings can be removed with scouring powder and soap. When waxing the diskettes, make sure the surface is even. This will allow the diskette to spin faster, resulting in better access time. 3. Do not fold diskettes unless they do not fit into the drive. "Big" diskettes may be folded and used in "little" disk drives. 4. Never insert a diskette into the drive upside down. The data can fall off the surface of the disk and jam the intricate mechanics of the drive. 5. Diskettes cannot be backed up by running them through the xerox machine. If your data is going to need to be backed up, simply insert two diskettes into the drive. Whenever you update a document, the data will be written on both diskettes. 6. Diskettes should not be inserted or removed from the drive while the red light is flashing. Doing so could result in smeared or possibly unreadable text. Occasionally the red light remains flashing in what is known as a "hung" or "hooked" state. If your system is "hooking" you will probably need to insert a few coins before being allowed access to the slot. 7. If your diskette is full and you need more storage space, remove the disk from the drive and shake vigorously for 2 minutes. This will pack the data enough (Data Compression) to allow for more storage. Be sure to cover all the openings with scotch tape to prevent loss data. 8. Access time can be greatly improved by cutting more holes in the diskette jacket. This will provide more simultaneous access points to the disk. 9. Diskettes may be used as coasters for beverage glasses, provided that they are properly waxed beforehand. Be sure to wipe the diskettes dry before using. (see item 2 above) 10. Never use scissors and glue to manually edit documents. The data is stored much too small for the naked eye, and you may end up with data from some other document stuck in the middle of your document. Razor blades and scotch tape may be used, however, provided the user is equipped with an electron microscope. 11. Periodically spray diskettes with insecticide to prevent system bugs from spreading. One of Microsoft's finest technicans was drafted and sent to boot camp. At the rifle range, he was given some instruction, a rifle, and bullets. He fired several shots at the target. The report came from the target area that all attempts had completely missed the target. The technician looked at his rifle, and then at the target. He looked at the rifle again, and then at the target again. He put his finger over the end of the rifle barrel and squeezed the trigger with his other hand. The end of his finger was blown off, whereupon he yelled toward the target area, "It's leaving here just fine, the trouble must be at your end!"